Flywheel Installation (Tc) - Husqvarna TE 250-310 2012 I.E. Workshop Manual

ENGINE REASSEMBLY
TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA

Flywheel installation (TC)

Clean flywheel rotor to remove any debris suspended in swirling oil and captured
by the magnets. Fit the tab (1) to the crankshaft.
Refit the rotor (2). Hold the rotor (2) to prevent rotation and place an aluminium
shim or dummy gear between the primary drives gears on the right side, again
to prevent rotation. Tighten the nut (3) to 75 Nm, 7.5 Kgm, 54.3 ft/lb. Use a 17
mm wrench.
2
3
H11122
Workshop Manual Ed. 12-2011
H.41