Headlamp, Tail Light (Te); Headlamp Adjustment; Headlamp Bulbs Replacement - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
A
Workshop Manual Ed. 12-2011
ELECTRICAL SYSTEM
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA

Headlamp, tail light (TE)

Headlamp adjustment

The headlamp features a twin bulb for low and high beam and a festoon bulb
for the city or parking light. Beam setting needs to be performed accurately;
proceed as follows:
- Place the motorcycle 10 metres away from a vertical wall;
- The motorcycle must be on level ground and the optical axis of the headlamp
must be perpendicular to the wall;
- The motorcycle must be upright;
- Measure the height from the ground to the centre of the lamp and draw a
cross on the wall at the same height;
- When the low beam is on, the upper edge between dark and lit zone should
be at 9/10th of the height of headlamp centre from ground. Beam height can
be raised or lowered turning the screw (1).

Headlamp bulbs replacement

Proceed as follows to reach the headlamp bulbs:
- remove the upper retaining screw securing headlamp fairing to dashboard
bracket (A);
- slide the headlamp fairing (B) forward and pull upwards (C) to ease it off the
two lower mounts;
- remove the headlamp fairing (1);
- slide off the rubber boot (2);
- release the clip (3) and remove the bulb holder (4);
- remove the bulb (5).
To replace the parking light bulb (6) extract it from the inside cover.
Once the tail light has been replaced, reverse the above procedure to reas-
semble.
H11133
M.30