Ignition And Gear Sensor Cable Connection; Routing Of Rear Chassis Cables, Tail Light Connection, Flasher Contactor; Clip Installation On Fuse Holders - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
28
29
31
30
ELECTRICAL SYSTEM
TXC 250 - 310 2012 I.E. USA

• Ignition and gear sensor cable connection

Connect the ignition (26) and gear sensor (27) connectors as shown.

• Routing of rear chassis cables, tail light connection, flasher contactor

Route the rear end of the wiring (28) as shown in the figure.
Connect the tail light/turning indicators connector (29) (TE).
- Connect the connector (30) to the flasher (TE).
- Connect the connector (31) to the solenoid starter.
H00947

• Clip installation on fuse holders

Install the suitable clips (33) on the three fuse holders.
M.51
Workshop Manual Ed. 12-2011