Friction Plate To Clutch Housing Clearance; Clutch Spring - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
Workshop Manual Ed. 12-2011
ENGINE OVERHAUL
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA

Friction plate to clutch housing clearance

Measure clearance "A" between clutch housing (2) and plate (1) with a feeler
gauge and compare measured clearance with the table below.
If measured clearance exceeds the service limit, replace clutch
plates or housing and repeat measurement. If measurement is still
outside the service limit, replace the complete clutch assembly.

Clutch spring

Measure the free length "L" of each spring with a calliper.
New spring L= 37.3 mm (1.4685 in.).
Service limit: 35 mm (1.3779 in.).
Change any spring that is outside the service limit.
G.16
STANDARD
0.30-0.50 mm
(0.012-0.020 in.)
SERVICE LIMIT
0.6 mm
(0.024 in.)