Removing The Rear Wheel - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA
1
2
3
CHASSIS AND WHEELS

Removing the rear wheel

Set a stand or a block under the engine and see that the rear wheel is lifted
from the ground.
Unscrew the nut (1) of the wheel axle (3) and extract it. It is not necessary to
loosen the chain tensioners (2); in this way, the chain tension will remain un-
changed after reassembly. Extract the complete rear wheel, keeping the spacers
located at the hub sides. To reassemble, reverse the
above procedure remembering to insert the brake disc into the calliper.
Do not operate the rear brake pedal when the wheel has been re-
moved; this causes the calliper pistons to move outwards.
2
After removal, lay down the wheel with brake disc on top.
After reassembly, depress the brake pedal until the pads are against
H10172
the brake disc.
Tightening torque figures
1: 142.1 Nm, 14.5 Kgm, 104.8 ft/lb
H10173
Y.9
Workshop Manual Ed. 12-2011