Flywheel Cover Installation - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
3
2
4 4
5
3
2
ENGINE REASSEMBLY
TXC 250 - 310 2012 I.E. USA

Flywheel cover installation

TE-TXC
Install the stator (1) with its mark lined up with the flywheel cover mark and tighten
the retaining screws (2) (use a 4 mm Allen
4
wrench, 6 Nm, 0.6 Kgm, 4.3 ft/lb + Loctite 272).
Insert the cable guide (3) into its seat in the cover and tighten the two retaining
5
screws (4) of the pick-up sensor (5) with its plate (6 Nm, 0.6 Kgm, 4.3 ft/lb +
Loctite 272).
4
Install the flywheel cover (7) with its gasket and tighten the six screws (8) to 6
Nm, 0.6 Kgm, 4.3 ft/lb.
2
Make sure the two centring bushings (6) are in place.
1
H11079
TC
2
1
H11080
TE-TXC
8
8
H11081
H.53
TC
8
7
8
H11082
Workshop Manual Ed. 12-2011