Operation Manual For "Husqvarna Service Tool" For Injection Fuel Feeding System (Te-Txc) - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
TE
F
5
4
G
FUEL INJECTION SYSTEM
TXC 250 - 310 2012 I.E. USA
Operation Manual for "HUSQVARNA SERVICE TOOL" for injection fuel
feeding system (TE-TXC)
The injection fuel feeding system does not require scheduled maintenance.
The "HUSQVARNA SERVICE TOOL" part no. 8000 H3898 lets you test system
components in the event of a malfunction.
TE = A malfunction is indicated by the word "FAIL" appearing in the right-hand
portion of the dashboard display when the ignition key is set to ON and the right
switch is set to RUN.
The "HUSQVARNA SERVICE TOOL" is composed of:
1) "Diagnostic Tool" Software CD-ROM, including User Guide (PDF), Operation
Manual (PDF);
H10164
- User Guide hard-copy;
- Operation Manual hard-copy;
6
2) Diagnosis module part no. 8000H3902
3) Bike-module connection cable part no. 8000 H3899 (KEIHIN, MIKUNI
3
MY11)
4) Module-PC USB cable part no. 8000 H3903
5) Do not use
6) Do not use
1
After installing the Diagnostic Tool Software according to the instructions provided
in the User Guide, proceed as follows:
- Remove the front headlight fairing/number holder as described in the relevant
section;
- slip off the cap (B) of the ECU interface connector (C);
2
- connect the Kit cable (3) to the connector (C);
- Connect the USB cable (4) to the PC;
TE = Turn the ignition key (F) to ON
H02374
TXC = Check that switch (G) is in 'RUN position';
- start the "Diagnostic Tool" software you have installed and perform the
required tests.
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 - O2 SENSOR (detects lean or rich mixture).
H10165
In case of throttle body (H) removal and/or replacement, it is nec-
essary to carry out the T.P.S. adjustment again by selecting the
relevant option ("T.P.S. idle adjustment").
This diagnostic software can check the following injection param-
eters:
AIR TEMPERATURE (air temperature in the intake manifold);
WATER TEMPERATURE (engine coolant temperature);
AIR PRESSURE (atmospheric pressure in current location and at current
altitude);
THROTTLE POSITION (throttle opening rate);
BATTERY (battery voltage);
GEAR SHIFT POSITION (currently selected gear shift position);
INJECTOR (fuel injection pulse width);
IGNITION COIL (device that stores energy in the reel and discharges it to
the spark plug);
O2 SENSOR HEATER (heats O2 sensor up to a temperature that will
provide a stable output);
S.5
Workshop Manual Ed. 12-2011