ENGINE REASSEMBLY
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
Flywheel installation (TC)
Clean flywheel rotor to remove any debris suspended in swirling oil and captured
by the magnets. Fit the tab (1) to the crankshaft.
Refit the rotor (2). Hold the rotor (2) to prevent rotation and place an aluminium
shim or dummy gear between the primary drives gears on the right side, again
to prevent rotation. Tighten the nut (3) to 75 Nm, 7.5 Kgm, 54.3 ft/lb. Use a 17
mm wrench.
2
3
H11122
Workshop Manual Ed. 07-2012
H.40