Start-Up Relay Removal (Te-Txc); Condenser (Tc) - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
2
Workshop Manual Ed. 12-2011
GENERAL PROCEDURES
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA

Start-up relay removal (TE-TXC)

- Remove saddle and left-hand side panel (in this order) as outlined in the
relevant paragraphs.
- Disconnect the negative and positive cables of the battery.
- Disconnect the starter motor positive cable (1) from the solenoid starter.
- Disconnect the connector (2) and remove the solenoid starter (3) from its
mount.

Condenser (TC)

- Cut the clamp (1) and disconnect the connector (2).
- Pull outwards the condenser (3) so that it comes out of the supporting bracket
(4).
1
H10021
This operation must be performed with a cool engine.
4
E.18
3
H11106