Engine Oil Replacement And Mesh Filters-Filter Cartridge Cleaning Or Replacement - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
3a
3c
4
H02336
Workshop Manual Ed. 12-2011
SETTINGS AND ADJUSTMENTS
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA
Engine oil replacement and mesh filters-filter cartridge cleaning or replace-
ment
Drain the oil with WARM ENGINE; proceed as follows:
- Remove the oil filler cap (2).
- The oil sump guard (A) may be left in place. However, the procedure will be
easier with the guard removed.
- Place an oil drain pan under the engine.
(TE-TC-TXC 250)
- Remove oil drain plug (3) and filter (4), drain the oil and clean the plug mag-
net.
- Wash the filter (4) with petrol and refit it into its seat.
250
(TE 310)
- loosen tie (3a) without disconnecting tube (3b);
- unscrew hose tail (3c), remove mesh filter (4) and drain the used oil.
- Unscrew the screws (5) and remove cover (6) together with filter (7).
- Change the filter (7) and refit the assembly making sure to fit the Belleville
washer (8) in the correct position.
(TE-TC-TXC 250)
- Refit the drain plug (3) (25 Nm - 2.5 Kgm - 33.89 ft/lb) and the oil sump guard
(A).
(TE 310)
- Reassemble fitting (3c), screw clamp (3a), and refit the engine cover (A).
- Fill with the specified quantity of oil.
310 For recommended oil type and quantity, see "Capacities" table in Section
"A".
3b
Be careful not to touch hot engine oil.
H02335
WARNING When assembling filter to cover, make sure to fit the filter
oil seal (A) first onto the cover (6).
6
D.18
A
7
8
H00977-1