Network Settings; Basic Settings; Table 7: Change Binding Email Option; Table 8: Ucm6510 Network Settings->Basic Settings - Grandstream Networks UCM6510 User Manual

Enter the password
of the account
Email Address

Network Settings

After successfully connecting the UCM6510 to the network for the first time, users could log in the web GUI
and go to Settings->Network Settings to configure the network parameters for the device. Select each
tab in web GUI->Settings->Network Settings page to configure LAN/WAN settings, 802.1X and Port
Forwarding.
Note:
To connect the UCM6510 to network, T1/E1/J1 data trunk can also be used, instead of using the WAN/LAN
port. Please see section
[DATA TRUNK]

Basic Settings

Please refer to the following tables for basic network configuration parameters on the UCM6510.
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6510. The
default setting is "Route".


Method

Specifies the Maximum Transmission Unit. (By default its 1500)
MTU
IPv4 Address
Enter the preferred DNS server address. If Preferred DNS is configured, the
Preferred DNS Server
UCM6510 will use it as Primary DNS server.

Table 7: Change Binding Email option

Enter the current login user credential for UCM6510
Email Address is used to retrieve password when password is lost
to use UCM6510 data trunk to connect the device to Internet.
Table 8: UCM6510 Network Settings->Basic Settings
Route
WAN port interface will be used for uplink connection. LAN port interface will be
used to serve as router.
Switch
WAN port interface will be used for uplink connection. LAN port interface will be
used as bridge for PC connection.
Dual
Both ports can be used for uplink connection. Users will need assign LAN 1 or
LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface if static IP is used for the interface.
UCM6510 IP PBX User Manual
P a g e | 53