Figure 25: Add Mac Address Bind; Figure 26: Batch Add Mac Address Bind - Grandstream Networks UCM6510 User Manual

User needs to set the device MAC address and the IP that will be bound to it (the IP address needs to be
within the UCM6510 DHCP range).
In order to bind a batch of listed MAC addresses, user needs to check first the MAC addresses to bind and
click on
the addresses.
After Clicking "OK" to confirm the binding, the "Bind Status" will change from "Unbind" to "Binding".
802.1X
IEEE 802.1X is an IEEE standard for port-based network access control. It provides an authentication
mechanism to device before the device is allowed to access Internet or other LAN resources. The UCM6510
supports 802.1X as a supplicant/client to be authenticated. The following diagram and figure show
UCM6510 uses 802.1X mode "EAP-MD5" on WAN port as client in the network to access Internet.

Figure 25: Add MAC Address Bind

. A confirmation popup will be shown, click

Figure 26: Batch Add MAC Address Bind

UCM6510 IP PBX User Manual
to bind
P a g e | 60