Grandstream Networks UCM6510 User Manual page 196

Disable This Route
Password
Call Duration Limit
Maximum Call Duration
Warning Time
Warning Repeat Interval
PIN Groups
Password
Privilege Level
Enable Filter on Source
Caller ID
After creating the outbound route, users can choose to enable and disable
it. If the route is disabled, it will not take effect anymore. However, the route
settings will remain in UCM. Users can enable it again when it's needed.
Configure the password for users to use this rule when making outbound
calls.
Once call duration limit is enabled, it will set the maximum duration of call-
blocking.
User can customize the maximum call duration (in seconds) that is allowed
for the outbound call. By default, this value is set to 0 means there is no
limit for the call duration.
This option will give caller warning when call duration is approaching to its
limit. If the warning time is set to 'y', the warning tone will be played to caller
when y seconds is left to end the call by UCM.
Once this option is set to 'z', it will repeatedly be warning caller every z
seconds after the first warning.
If selected, the Password, Privilege Level and Enable Filter on Source
Caller ID will not take effect.
Configure the password for users to use this rule when making outbound
calls.
Select privilege level for the outbound rule.
Internal: The lowest level required. All users can use this rule.

Local: Users with Local, National, or International level are allowed to
use this rule.

National: Users with National or International level are allowed to use
this rule.

International: The highest level required. Only users with international
level can use this rule.
The default setting is "Disable". Please be aware of the potential security
risks when using "Internal" level, which means all users can use this
outbound rule to dial out from the trunk.
When enabled, users could specify extensions allowed to use this outbound
route. "Privilege Level" is automatically disabled if using "Enable Filter on
Source Caller ID".
The following two methods can be used at the same time to define the
extensions as the source caller ID.
3. Select available extensions/extension groups from the left to the right.
This allows users to specify arbitrary single extensions available in the
PBX.
UCM6510 IP PBX User Manual
P a g e | 195