Grandstream Networks UCM6510 User Manual page 277

Feature Misc
Feature Code Digits Timeout
Call Park
Parked Lots
Use parklot as extension
Parking Timeout (s)
Feature Codes
Voicemail Access Code
My Voicemail
Agent Pause
Agent Unpause
Paging Prefix
Intercom Prefix
Blacklist Add
Blacklist Remove

Default Setting: 1000.

Configure the maximum interval (in milliseconds) between the
digits input to activate the feature code.

Default Extension: 700.

During an active call, initiate blind transfer and then enter this
code to park the call.

Default Extension: 701-720.

These are the extensions where the calls will be parked, i.e.,
parking lots that the parked calls can be retrieved.
If checked, the parklot number will be used as extension, you can
transfer to the parklot number for parking your call. If the parking lots
overlap existing extensions, there will be conflict.

Default setting: 300.

This is the timeout allowed for a call to be parked. After the
timeout, if the call is not picked up, the extension who parks the
call will be called back.

Default Code: *98.

Enter *98 and follow the voice prompt. Or dial *98 followed by the
extension and # to access the entered extension's voicemail box.

Default Code: *97.

Press *97 to access the voicemail box.

Default Code: *83.

Pause the agent in all call queues.

Default Code: *84.

Unpause the agent in all call queues.

Default Code: *81.

To page an extension, enter the code followed by the extension
number.

Default Code: *80.

To intercom an extension, enter the code followed by the
extension number.

Default Code: *40.

To add a number to blacklist for inbound route, dial *40 and follow
the voice prompt to enter the number.

Default Code: *41.

To remove a number from current blacklist for inbound route, dial
*41 and follow the voice prompt to remove the number.
UCM6510 IP PBX User Manual
P a g e | 276