This section explains configurations for system-wide parameters on the UCM6100. System settings are
under "Settings" tag on UCM6100 web GUI. System settings include User Management, Network Settings,
Firewall, Change Password, LDAP server, HTTP server, Email settings, Time Settings, NTP Server,
Recordings Storage and Login Timeout settings.
Network Settings
After successfully connecting the UCM6100 to the network for the first time, users could login the Web GUI
and go to System SettingsNetwork Settings to configure the network parameters for the device.
The network setting options are similar for UCM6108 and UCM6116. Additional network functions and
settings are available for UCM6102 and UCM6104:
•
UCM6102 supports Route/Switch/Dual mode functions.
•
UCM6104 supports Switch/Dual mode functions.
In this section, all the available network setting options are listed for each model. Select each tab in web
GUISystem SettingsNetwork Settings page to configure LAN settings, WAN settings (UCM6102
only), 802.1X and Port Forwarding (UCM6102 only).
Basic Settings
Please refer to the following tables for basic network configuration parameters on UCM6102, UCM6104,
and UCM6108/UCM6116 respectively.
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6102.
The default setting is "Route".
•
•
Method
•
MTU
Specifies the Maximum Transmission Unit. (By default, it is 1500)
SYSTEM SETTINGS
Table 6: UCM6102 Network SettingsBasic Settings
Route
WAN port interface will be used for uplink connection. LAN port interface will
be used to serve as router.
Switch
WAN port interface will be used for uplink connection. LAN port interface will
be used as bridge for PC connection.
Dual
Both ports can be used for uplink connection. Users will need assign LAN 1 or
LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface.
UCM6100 Series User Manual
P a g e
49
|