Create New Iax Extension; Table 35: Sip Extension Configuration Parameters - Specific Time; Table 36: Iax Extension Configuration Parameters - Basic Settings - Grandstream Networks UCM6510 User Manual

Call Duration Limit
Custom Call-info for Auto
Answer
Table 35: SIP Extension Configuration Parameters – Specific Time
Specific Time
Time Condition

Create New IAX Extension

The UCM6510 supports Inter-Asterisk eXchange (IAX) protocol. IAX is used for transporting VoIP telephony
sessions between servers and terminal devices. IAX is similar to SIP but also has its own characteristic.
For more information, please refer to RFC5465.
To manually create new IAX user, go to web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New IAX Extension" and a new dialog window will show for users to fill in the extension information.
The configuration parameters are as follows.
Table 36: IAX Extension Configuration Parameters – Basic Settings
General
Extension
CallerID Number
Permission
SIP/IAX Password
Enable Voicemail
Voicemail Password
The maximum duration of call-blocking.
If enabled, when a call is sent to this extension from UCM, the SIP INVITE
message will contain a Call-info header indicating auto answer.
Click to add Time Condition to configure specific time for this extension.
The extension number associated with the user.
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
Configure the password for the user. A random secure password will be
automatically generated. It is recommended to use this password for
security purpose.
Enable voicemail for the user. The default setting is "Yes".
Configure voicemail password (digits only) for the user to access the
voicemail box. A random numeric password is automatically generated. It
UCM6510 IP PBX User Manual
P a g e | 134