System Settings; Network Settings; Basic Settings; Table 5: Ucm6510 Network Settings->Basic Settings - Grandstream Networks UCM6510 User Manual

This section explains configurations for system-wide parameters on the UCM6510. Those parameters
include Network Settings, Firewall, Change Password, LDAP server, HTTP server, Email settings, Time
Settings and NTP Server settings.

NETWORK SETTINGS

After successfully connecting the UCM6510 to the network for the first time, users could log in the web
GUI and go to Settings->Network Settings to configure the network parameters for the device. Select
each tab in web GUI->Settings->Network Settings page to configure LAN/WAN settings, 802.1X and
Port Forwarding.
Note:
To connect the UCM6510 to network, T1/E1/J1 data trunk can also be used, instead of using the
WAN/LAN port. Please see section
Internet.

BASIC SETTINGS

Please refer to the following tables for basic network configuration parameters on the UCM6510.
Method
Firmware Version 1.0.0.25

SYSTEM SETTINGS

[DATA TRUNK]
Table 5: UCM6510 Network Settings->Basic Settings
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6510.
The default setting is "Route".

Route
WAN port interface will be used for uplink connection. LAN port interface will
be used to serve as router.

Switch
WAN port interface will be used for uplink connection. LAN port interface will
UCM6510 IP PBX User Manual
to use UCM6510 data trunk to connect the device to
Page 31 of 233