Grandstream Networks UCM6510 User Manual page 186

Caller ID
CallerID Name
Auto Record
Advanced Settings
Codec Preference
DID Mode
DTMF Mode
Enable Qualify
Qualify Timeout
Qualify Frequency
Configure the Caller ID. This is the number that the trunk will try to use
when making outbound calls. For some providers, it might not be possible
to set the CallerID with this option and this option will be ignored.
When making outgoing calls, the following rules are used to determine
which CallerID will be used if they exist:

The CallerID configured for the extension will be looked up first.

If no CallerID configured for the extension, the CallerID configured for
the trunk will be used.

If the above two are missing, the "Global Outbound CID" defined in
Web GUI->PBX->Internal Options->General will be used.
Configure the name of the caller to be displayed when the extension has
no CallerID Name configured.
Enable automatic recording for the calls using this trunk (for SIP trunk
only). The default setting is disabled. The recording files can be accessed
under web GUI->CDR->Recording Files.
Select audio and video codec for the VoIP trunk. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723,
OPUS, iLBC, ADPCM, VP8, H.264, H.263, H.263p.
Configure where to get the destination ID of an incoming SIP call, from SIP
Request-line or To-header. The default is set to "Request-line".
Configure the default DTMF mode when sending DTMF on this trunk.

Default: The global setting of DTMF mode will be used. The global
setting for DTMF Mode setting is under web UI->PBX->SIP Settings-
>ToS.

RFC2833: Send DTMF using RFC2833.

Info: Send DTMF using SIP INFO message.

Inband: Send DTMF using inband audio. This requires 64 bit codec,
i.e., PCMU and PCMA.

Auto: Send DTMF using RFC2833 if offered. Otherwise, inband will be
used.
If enabled, the UCM6510 will regularly send SIP OPTIONS to the device
to check if the device is still online. The default setting is "No".
When "Enable Qualify" option is set to "Yes", configure the timeout (in ms)
for the Qualify SIP message. If no response is received within the timeout,
the device is considered offline. The default setting is 1000ms.
When "Enable Qualify" option is set to "Yes", configure the interval (in
seconds) of the SIP OPTIONS message sent to the device to check if the
device is still online. The default setting is 60 seconds.
UCM6510 IP PBX User Manual
P a g e | 185