The UCM6510 supports ring group feature with different ring strategies applied to the ring group members.
This section describes the ring group configuration on the UCM6510.
Configure Ring Group
Ring group settings can be accessed via web GUI->PBX->Call Features->Ring Group.
Click on "Create New Ring Group" to add ring group.
Click on
to edit the ring group. The following table shows the ring group configuration parameters.
Click on
to delete the ring group.
Ring Group Name
Extension
Ring Group Members
Selected LDAP Numbers
Ring Strategy
RING GROUP
Figure 136: Ring Group
Table 75: Ring Group Parameters
Configure ring group name to identify the ring group. Letters, digits, _ and -
are allowed.
Configure the ring group extension.
Select available users from the left side to the ring group member list on the
right side. Click on
Select available remote users from the left side to the ring group member
list on the right side. Click on
LDAP Sync must be enabled first.
Select the ring strategy. The default setting is "Ring in order".
Ring simultaneously
Ring all the members at the same time when there is incoming call to
the ring group extension. If any of the member answers the call, it will
stop ringing.
Ring in order
Ring the members with the order configured in ring group list. If the first
member doesn't answer the call, it will stop ringing the first member and
start ringing the second member.
UCM6510 IP PBX User Manual
to arrange the order.
to arrange the order. Note:
P a g e
|
228