Grandstream Networks UCM6510 User Manual page 56

Layer 2 QoS Assign the VLAN tag of the layer 2 QoS packets for LAN port.
802.1Q/VLAN Tag The default value is 0.
Layer 2 QoS 802.1p Assign the priority value of the layer 2 QoS packets for LAN port.
Priority Value The default value is 0.
LAN 1 / LAN 2 (when Method is set to "Dual")
If "Dual" is selected as "Method", users will need assign the default interface to be
LAN 1 (mapped to UCM6510 WAN port) or LAN 2 (mapped to UCM6510 LAN port)
Default Interface
and then configure network settings for LAN 1 and LAN 2. The default interface is
LAN 2.
IP Method Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
Subnet Mask
255.255.0.0.
Enter the gateway IP address for static IP settings when the port is assigned as
Gateway IP
default interface. The default setting is 0.0.0.0.
DNS Server 1 Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
DNS Server 2 Enter the DNS server 2 address for static IP settings.
User Name Enter the user name to connect via PPPoE.
Password Enter the password to connect via PPPoE.
Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is
Layer 2 QoS
802.1Q/VLAN Tag 0.
Layer 2 QoS 802.1p Assign the priority value of the layer 2 QoS packets for LAN port. The default value
Priority Value is 0.
IPv6 Address
WAN (when "Method" is set to "Route")
IP Method Select Auto or Static. The default setting is Auto
Enter the IP address for static IP settings.
IP Address
Enter the Prefix length for static settings. Default is 64
IP Prefixlen
DNS Server 1 Enter the DNS server 1 address for static settings.
DNS Server 2 Enter the DNS server 2 address for static settings.
LAN (when Method is set to "Route")
Select Disable, Auto or DHCPv6.
Disable: the DHCPv6 server is disabled.
DHCP Server
Auto: Stateless address auto configuration using NDP protocol.
DHCPv6: Stateful address auto configuration using DHCPv6 protocol.
DHCP Prefix Enter DHCP prefix. (Default is 2001:db8:2:2::)
DHCP prefixlen Enter the Prefix length for static settings. Default is 64
UCM6510 IP PBX User Manual
P a g e | 55