Network Settings; Basic Settings; Table 8: Change Binding Email Option; Table 9: Ucm6200 Network Settings->Basic Settings - Grandstream Networks UCM6202 User Manual

Enter the password
of the account
Email Address

Network Settings

After successfully connecting the UCM6200 to the network for the first time, users could login the Web GUI
and go to Settings->Network Settings to configure the network parameters for the device.

UCM6200 supports Route/Switch/Dual mode functions.
In this section, all the available network setting options are listed for all models. Select each tab in web
GUI->Settings->Network Settings page to configure LAN settings, WAN settings, 802.1X and Port
Forwarding.

Basic Settings

Please refer to the
UCM6202/UCM6204/UCM6208.
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6200. The default
setting is "Route".

Route
WAN port interface will be used for uplink connection. LAN port interface will be used
to serve as router.

Switch
Method
WAN port interface will be used for uplink connection. LAN port interface will be used
as bridge for PC connection.

Dual
Both ports can be used for uplink connection. Users will need assign LAN 1 or LAN 2
as the default interface in option "Default Interface" and configure "Gateway IP" for
this interface.
Preferred DNS Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to use it
Server as Primary DNS server.
WAN (when "Method" is set to "Route")
IP Method Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Subnet Mask Enter the subnet mask address for static IP settings. The default setting is 255.255.0.0.
Gateway IP Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
DNS Server 1

Table 8: Change Binding Email option

Enter the current login user credential for UCM6200
Email Address is used to retrieve password when password is lost
following tables for
Table 9: UCM6200 Network Settings->Basic Settings
UMC6200 Series User Manual
basic network configuration parameters on
P a g e | 44