Grandstream Networks UCM6510 User Manual page 183

From Domain
From User
Username
Password
Auth ID
Auth Trunk
Auto Record
Advanced Settings
Codec Preference
Send PPI Header
Send PAI Header
Outbound Proxy Support
Configure the actual domain name where the extension comes from. This
can be used to override the "From" Header.
For example, "trunk.UCM6510.provider.com" is the From Domain in From
Header: sip:1234567@trunk.UCM6510.provider.com.
Configure the actual user name of the extension. This can be used to
override the "From" Header. There are cases where there is a single ID for
registration (single trunk) with multiple DIDs.
For example, "1234567" is the From User in From
sip:1234567@trunk.UCM6510.provider.com.
Enter the username to register to the trunk from the provider when
"Register SIP Trunk" type is selected.
Enter the password to register to the trunk from the provider when
"Register SIP Trunk" is selected.
Enter the Authentication ID for "Register SIP Trunk" type.
If enabled, the UCM will send 401 response to the incoming call to
authenticate the trunk.
Enable automatic recording for the calls using this trunk (for SIP trunk
only). The default setting is disabled. The recording files can be accessed
under web GUI->CDR->Recording Files.
Select audio and video codec for the VoIP trunk. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723,
OPUS, iLBC, ADPCM, VP8, H.264, H.263, H.263p.
If enabled, the SIP INVITE message sent to the trunk will contain PPI (P-
Preferred-Identity) header. The default setting is "No".
Note:
"Send PPI Header" and "Send PAI Header" cannot be enabled at the same
time. Only one of the two headers is allowed to be contained in the SIP
INVITE message.
If enabled, the SIP INVITE message sent to the trunk will contain PAI (P-
Asserted-Identity) header. The default setting is "No".
Note:
"Send PPI Header" and "Send PAI Header" cannot be enabled at the same
time. Only one of the two headers is allowed to be contained in the SIP
INVITE message.
Select to enable outbound proxy in this trunk. The default setting is "No".
UCM6510 IP PBX User Manual
Header:
P a g e | 182