System Settings; Network Settings; Basic Settings; Table 5: Ucm6510 Network Settings->Basic Settings - Grandstream Networks UCM6510 User Manual

This section explains configurations for system-wide parameters on the UCM6510. Those parameters
include Network Settings, Firewall, Change Password, LDAP server, HTTP server, Email settings, Time
Settings and NTP Server settings.

NETWORK SETTINGS

After successfully connecting the UCM6510 to the network for the first time, users could login the web GUI
and go to Settings->Network Settings to configure the network parameters for the device. Select each tab
in web GUI->Settings->Network Settings page to configure LAN/WAN settings, 802.1X and Port
Forwarding.

BASIC SETTINGS

Please refer to the following tables for basic network configuration parameters on the UCM6510.
Method
Preferred DNS Server
WAN (when "Method" is set to "Route")
IP Method
Gateway IP
Subnet Mask
Firmware Version 1.0.0.5

SYSTEM SETTINGS

Table 5: UCM6510 Network Settings->Basic Settings
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6510.
The default setting is "Route".

Route
WAN port interface will be used for uplink connection. LAN port interface will
be used to serve as router.

Switch
WAN port interface will be used for uplink connection. LAN port interface will
be used as bridge for PC connection.

Dual
Both ports can be used for uplink connection. Users will need assign LAN 1
or LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface.
Enter the preferred DNS server address.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Enter the subnet mask address for static IP settings. The default setting is
UCM6510 IP PBX User Manual Page 27 of 192