iLBC
H.264
H.263P
VP8
Internal Options/PIN Groups
The UCM6510 supports pin group. Once pin group is configured, users can apply pin group to specific
outbound routes. When placing a call on pin protected outbound routes, caller will be asked to input the group
pin number, this feature can be found on the webGUI under " PBX->Internal Options->PIN Groups ".
Name
Record In CDR
PIN Number
PIN Name
Once user click on
Once PIN Groups and members Created it should look like:
Configure the payload type for iLBC. The default setting is 97.
Configure the payload type for H.264. The default setting is 99.
Configure the payload type for H.263+. The default setting is 100 103.
Configure the payload type for VP8. The default settings is 108.
Table 90: PIN Group
Specify the name of the group
Specify whether to enable/disable record in CDR
Specify the code that will asked once dialing via a trunk
Specify the name of the PIN
the following figure pop's up for configuring the new Pin.
Figure 179: Create New PIN Group
UCM6510 IP PBX User Manual
P a g e
|
284