Steering Wheel And Throttle Lever Calibration; Interface (Bt Speed) - GRAUPNER X-8E Manual

NORMAL
BACK
0%
ST
0%
L150%
TH
F150%
0%
0%
CH3
CH3
Stick Calibration
BACK
0 %
LEFT
S1008_X-8E_jh_V1

Steering wheel and throttle lever calibration

If the center position of steering wheel or if the throttle lever does
not neutralize to 0% control travel, you can check and correct it
as follows.
Stick calibration step by step:
1. Go to the "M-SEL" menu and tap on an open model
memory slot to select.
2. Move to the "SERVO" menu without changing any trim
settings or other program settings.
3. Center the steering wheel or the throttle lever by moving
the steering wheel and the throttle lever to the middle
R150%
position. If the throttle lever and the steering wheel are
B150%
correctly centered, the display should match the one
shown at left.
4. One at a time, move the steering wheel and throttle lever
0%
as far as they will go in all directions without exerting force
0%
at their position limits. The values should register between
-100% and +100%.
5. If the throttle lever or the steering wheel does not reach
the desired values, tap the "Stick Calibration" button in
the "Secret Mode" option in the "H/W SET" menu.
6. Follow the prompts on the screen by moving the steering
wheel and the throttle lever in the directions shown and
keep them still. Confirm the position by tapping on the
ENT button. Repeat this procedure for all of the indicated
positions. If you have correctly calibrated all positions, a
confirmation message will be displayed. Tap "OK" to save
the calibrations. Tapthe "BACK" button to quit the pro-
cess and return to the submenu "Stick Calibration".

Interface (BT SPEED)

ENT
Use this menu to assign transmitter ports for telemetry data
transmission.
DATA PORT
Plug in the external Bluetooth module S8351 to the DATA port
on the rear side of the transmitter. In the BT SPEED line, FAST
or NORMAL will automatically select depending on the trans-
mission speed of the counterpart device.
USB PORT
Plug in the supplied connection cable 7168 to the micro USB
port on the rear side of the transmitter to establish a connection
with a PC.
25 / 48