Trim Set; Throttle Cut - GRAUPNER mz-32 HoTT Reference Manual

Graupner mz-32 Help Reference Manual
B06S2
of the current line settings to a different control function (channel).
The Group icon will set the trim as global or phase dependent.
The Value field shows the current value of the trim position for that channel.
Tapping on the Store field will copy the current trim setting to memory and reset the trim
value back to zero. This enables you to try different trim settings and view the differences
between the stored and current trim settings.
You can select from five different trim types depending on your needs and situation.
 Linear decrease of trim impact on both sides of the neutral position.
 Even change of trim impact over control range.
 Linear decrease of trim impact towards neutral position on lower part of the control
range.
 Linear decrease of trim impact over entire control range.
 Inverted linear decrease of trim impact over entire range.
The Travel field value determines the maximum trim travel.
B07S1
cut.
B08S1

TRIM SET

In the Trim Set menu, you can set the trim behavior
for each of your trims, giving you the most optimal
configuration for your trim settings.
You can have up to 8 different trims for each of your
flight controls. To add a new trim, tap on a number in
the number column to bring up the selection toolbar
and tap the + icon. You will need to select a channel
for which you would like to set up the trim.
To add a control, tap on the Ctrl field to select the
control type you will be using for that channel.
Tapping the Function name permits the re assignment

THROTTLE CUT

The Throttle Cut menu provides an easy way to control
your throttle on/off position.
The Control field determines which control is going to
be used for the throttle cut.
The Cut Off value determines at which position the
throttle cut will occur. For example, on gas motors you
would like to have your idle position at -100 but your
cutoff at -130.
The Trigger value determines the threshold position
when the throttle cut is engaged.
The Action field shows the active state of the throttle
Page 11 of 42 Help-Ref-EN-V1.0