No.
1
2
3
4
5
6
7
8
4.8.4.3.3.1 Show
Select this option to view the current values/options of the Multirate algorithm
parameters.
4.8.4.3.4 Update
Select this option to update any of the Multirate parameters. The Multirate
parameters are:
4.8.4.3.4.1 Multirate Enable/Disable
The Multirate Enable/Disable parameter controls whether the multirate
algorithm should be used to determine current optimal rates in both the uplinks
and the downlinks.
The default is Enable.
NOTE
The multirate algorithm should always be enabled. The option to disable it is available to enable
using a fixed rate to support certain tests. After each reset, the AU/µBST boots with the multirate
enabled, disregarding its status before the device was reset.
4.8.4.3.4.2 Uplink Basic Rate
The Basic Rate for all uplinks.
The available options are listed in Table 4-5 on page 125.
The default rate is the lowest rate BPSK 1/2 (rate 1).
BreezeMAX System Manual
Table 4-5: Rates (Modulation Schemes and Coding)
Rate
BPSK 1/2
BPSK 3/4
QPSK 1/2
QPSK 3/4
QAM16 1/2
QAM16 3/4
QAM64 2/3
QAM64 3/4
AU Menu
125