Table of Contents
Advertisement
Chapter 4 - Operation and Administration
4.7.3.1.6 Ma
nagement Port Managem
The
Management Port Management T
enabling/
NOTE
To prevent the und
MG
MT and DATA ports, the Data Port Manageme
automatically forced to Enabled upon disabling the Management Port Management Traffic, and vice
versa.
4.7.3.2
Data Port Parameters
These parameters define the IP parameters for the Data port connecting the base
station to the backbone. The DATA por
management, provided that IB manage
In-Band management via the DATA port is always enabled.
4.7.3.2.1
Data Port IP Address
The IP address of the DATA port.
The default is 1.1.1.3.
4.7.3.2.2 Data Port Subnet Mask
The subnet mask of the DATA port.
The d
efault is 255.255.255.0.
4.7.3.2.3 Da
ta Port Gateway
The Ga
teway IP address of the DAT
The default is 0.0.0.0.
4.7.3.2.4 Da
ta Port Management VLAN
Thi
s parameter defines the VLAN ID
to 4094 is configured for the Management VLAN ID, then the device will accept
management frame
Available values are 0-4094 or null (empty) for No VLAN.
The default is null (No V
4.7.3.2.5
D
ata Port Speed (NPU)
The speed of the Ethernet interface that operates always in full-duplex mode.
The available options are 100 Mbps and 1 Gbps.
The default speed is 100 Mbps.
110
disabling the MGMT port.
esired situation where ma
s only if their VLAN tag is the same as this value.
LAN).
ent Traffic Enable/Disable
raffic Enable/Disable parameter allows
nagement traffic is unintentionally disabled in both the
nt Traffic Enable/Disable parameter will be
t can also be used for In-Band (IB)
ment is enabled. In the current version
A port.
for management frames. If a value between 0
BreezeMAX System Manual
Advertisement
Table of Contents
