Table of Contents
Advertisement
Appendix B - Using the SU Installer Monitor Program
B.9.3
Disable ATPC and Set Tx Power
S
elect this option to temporarily disable ATPC for testing purposes. You will be
promp
ted to enter the requested Tx Power. The available values for the Tx Power
are from –20 dBm to 20 dBm using a 1 dBm resolution.
The default Tx Power is the last power level used before the ATPC al
disabled.
Upon finishing the test, enable ATPC to resume normal operation. If not enable
manually, ATPC will be enabled automatically after the next reset or
termination of the Telnet sess
B.9.4
Transmit Continuous OFDM
Select this option to transmit a continuous OFDM signal. This is possible only
when the unit is not connected (does not receive MAPs). You will be prompted to
enter the requested Tx Power. The available values for the Tx
-20 dBm to 20 dBm using a 1 dBm resolution.
The default Tx Power is the last power level used before the ATPC algorithm was
disabled.
Continuous OFDM transmission will continu
222
ion.
e until the next reset.
gorithm was
following
Power are from
BreezeMAX System Manual
d
Advertisement
Table of Contents
