Table of Contents
Advertisement
Chapter 2 - Installation
The IF cable connector should be properly sealed to protect against rain and
3
moisture.
Route the cable to the
4
2.1.8.4
Connecting the SU's IDU-ODU Cable
CAUTION
Use only Category
approved cables in Table 2-3 on page 36.
To connect the IDU-O
Remove the
1
and remove the service box.
Unscrew the top nut from the service box.
2
Route a straight, uncrimped Category 5E Ethernet cable (8-wire, 24 AWG)
3
through bot
Insert and c
4
preparing th
Connect the Ethernet cable to the IDU COM RJ-45 connector.
5
Reposition the service box and then tighten the top nut. Make sure that the
6
ext
ernal jack of the cable is well inside the service box to guarantee a good
seal.
Route the cable to the location selected for the indoor equipment.
7
Assemble an RJ-45 connector with a protecti
8
IDU-ODU cable.
NOTE
The length of the Indoor-to-Outdoor cable, together with the length of the Ethernet cable connecting
the CPE-IDU-1D to the data equipment, should not exceed 100 meters.
42
location selected for the indoor equipment.
5E 4x2x24# F
TP outdoor cables from an approved manufacturer. See list of
DU cable:
two screws holding the
h the top nut a
nd the body of the service box.
rimp the RJ-45
connector. Refer to
e cable.
waterproof service box to the outdoor unit
Appendix A
ve cover on the indoor end of the
BreezeMAX System Manual
for instructions on
Advertisement
Table of Contents
