Table of Contents
Advertisement
Chapter 4 - Operation and Administration
NOTE
Retransmission Rate is defined as:
100*Bytes Retransmitted/ (Unicast Bytes Transmitted to Wireless)
Note that unacknowledged bytes are retransmitted only if ARQ is enabled. Retransmission is
applicable only for information transmitted using either Best Effort (BE) or Non Real Time (NRT)
Quality of Service.
4.8.5.2
BER Test
The BER Test sub-menu enables to initiate a BER test on the link with a specific
SU, including definition o
results. It includes the following options:
Start Test
Stop Test
Show Test P
4.8.5.2.1
Start Test
Select this option
a test. The test will be i
parameters are:
4.8.5.2.1.1
SU MAC Address
The BER test is performed on a lin
of the applicable SU.
4.8.5.2.1.2
Number of Bytes
The number of BER test bytes to be transmitted. The available range is from
1,000 to 100,000,000 Bytes.
4.8.5.2.1.3 Rate
The rates to be used for the BER test in the uplink and downlink. Refer to Table
4-5 on page 125 for details on the available rates.
4.8.5.2.1.4
Burst Size (Bytes)
The burst size in byt
4.8.5.2.1.5 Test Priority
The service priority of the BER test. Se
affected by the test. The available options are RT (Real time), NRT (Non Real
Time), and
130
f test parameters, to terminate a test and to view test
arameters and Results
to define the parameters for a Bit Error Rate test and to initiate
nitiated after all parameters have been configured. The
es. The available range is from 500 to 4,000 Bytes.
BE (Best Effort).
k with a specific SU. This is the MAC address
rvices with higher priority will not be
BreezeMAX System Manual
Advertisement
Table of Contents
