Table of Contents
Advertisement
4.8.4.2
Unit Control
The AU Unit Control menu enables resetting the AU and managing the SW
versions of the module.
The Unit Control menu includes the following options:
Reset
Set Factory Defaults
SW Version Control
4.8.4.2.1 Re
set Unit
Select this option to reset the unit. To avoid unintentional reset, you will be
prompted to confirm the reset r
parameters are applied only after reset. Refer to
Parameters Summary
cha
ngeable in run time and which changes are applied only after reset.
4.8.4.2.2 Se
t Factory Defaults
Sel
ect this option to set the AU parameters to their factory default values. Refer to
NP
U/Micro Base Station Parameters Summary
the factory default values of these parameters. The parameters will revert to their
default values after the next reset.
4.8.4.2.3 SW
Versions Control
The AU
ca
Main: Each time the AU resets it will reboot using the version defined as
Main.
Shadow: Normally, the Shadow version is the backup version. Each time a
new S
replacing the previous Shadow Version.
The pr
ocess of upgrading to a new SW version is controlled by the NPU, and is
performed using one of the AU SW files installed in the NPU. If the specified AU
SW file does not exist in the AU, it will be downloaded to the AU and the
requested operation will be executed, as d
the AU, then actual loading is not necessary.
The
following options are availabl
4.8.4.2.3.1 Show Versions
Select this option to view the following information:
BreezeMAX System Manual
equest. Changes to some of the configurable
on page 177 for information on which parameters are
n contain tw
o SW versi
W File is d
ownloaded to
NPU/Micro Base Station
on page 177 for information on
ons:
the AU, it will be stor
ed as a Shadow version,
escribed below. If it already exists in
e in the SW Version Control menu:
AU Menu
119
Advertisement
Table of Contents
