Table of Contents
Advertisement
2.2.9
Installing the Base Station Chassis and
Modules
The indoor equipment should be installed as close as possible to the location
where the IF cable(s) enters the building. The location of the indoor equipment
should take into account its connection to the power source(s) and to the base
station networking equipment.
To install the Base Station chassis and modules:
Attach th
1
w
ashers supplied with the Cable Guide.
Install th
2
suitable ETSI rack adapters to the chassis. To provide a sufficient space for
the Cabl
space of
in the ca
Connect one end of a grounding c
3
rear pan
Connec
the cabi et, if applicable.
Carefully insert the modules into
4
their int
on modules' insertion).
P
lace bl
5
Connect the DATA port of the NPU
6
straight Ethernet cable to connect
lengt
when
If the MGMT port will be used for
7
a
ppropri
h
ub/sw
Connect the DC power cable to the power jack of the PIU module. If a
8
redundant PIU is installed, connect a DC power cable also to the second PIU
module. Connect the power cord(s) to the -48 VDC power source(s), as
follows.
Connect the black wire to the 48 VDC contact of the power source.
Connect the red wire to the + (Return) contact.
BreezeMAX System Manual
e Cable Guide to the top panel of the chassis
e chassis in a 19" cabinet. For installation i
e Guide and t
o allow air f
at least 1U between t
binet.
el of the chassis and
t the opposite end of the
n
ended locations (refe
ank covers over all of th unused slots.
h of
the Ethernet cable is 1
op
erating at 1 Gbps.
ate data equipm
ent (use a
itch/router). Th
e maximu
Installing the Modular Base Station Equipment
low for prevent
ing over-heating, leave a free
he u
pper covers of the chassis and ot
able to t
he ground terminal located on the
firm
ly tighten the grounding screw.
g
rounding cable to a ground conne
the relev
ant slots. Secure the modules in
r to
I
nserting Modules
e
to the backbone data e
to a hub/switch/router).
00
m when operating at 100 Mbps an
remote manag
ement, connect it to the
straight Ethernet cable to connect to
m length of the Ethernet cable is 100m
using the screws and
n a 21" cabinet, attach
her units
ction or to
on page 55 for instructions
quipment (use a
The maximum
d 70m
a
.
57
Advertisement
Table of Contents
