Table of Contents
Advertisement
C.2
File Loading Procedure
To load software files:
Verify that you have IP connectivity from your computer to the NPU/Micro
1
Base Station (either the MGMT or the DATA port). To verify the connection,
ping the unit's IP a
To perform the
2
-i hostaddre
where -i stands for binary mode an
to be upgraded (NPU/µBST ). The put command instructs the PC client to
send a file to the
Client.
For example, to load th
172.1
tftp -i 172.17.31.215 put npu_1_0_2_15
NOTE
It is recommended to upgrade all system elements with the latest software version. Nevertheless, it
is possible to upgrade each unit separately and independently.
Following a successful completion of the file loading process, the Transfer
3
succ
The unit decompresses the loaded file and checks the integrity of the new
4
version. The new version replaces the previous shadow version only after
verification. If verification tests fail, the loaded version will be rejected. The
unit will reject a file if either the file name or the version number matches the
current Main versions.
Check that the loaded versions exist in the unit:
5
To view the current NPU/µBST SW Versions in the unit:
Select Unit Control>SW Versions Control>Show Versions.
To view the current SU/AU SW files in NPU/µBST:
Select SU/AU>SW Files in NPU/
BreezeMAX System Manual
ddress and verify that PING replies are being received.
upgrade, use a DOS TFTP utility with the following syntax: tftp
ss put sourcefile
hostaddress. sourcefile is the name of the SW file in the PC
e file npu_1_0_2_15 to the NPU whose IP address is
7.31.215, use the following command:
essful DOS message is displayed.
d hostaddress is the IP address of the unit
µ
BST>Show Files.
File Loading Procedure
227
Advertisement
Table of Contents
