Table of Contents
Advertisement
4.7.2.3
Set Factory Defaults
Select this option to set the Base Station and NPU (or the Micro Base Station)
parameters to their facto
Parameters Summary
these parameters. The parameters will reve
reset.
NOTE
Setting the parameters of the NPU/ µBST to their default values will disable remote management of
the Base Station.
4.7.2.4
SW Version Control
The NPU/ BST can contain two SW versions:
Main: Each tim
as Main.
Shadow: Normally the Shadow version is the backup version. Each time a
new SW File is downloaded to the NPU/ µBST, it will be stored as a Shad
version, replacing the previous Shadow Version.
The typical process of upgrading to a new SW version includes the following
steps:
wnload the new SW File to the NPU/ µBST. It will be stored as the Shadow
Do
1
version.
Reset and run the module from its Shadow version. Note that at this stage,
2
after reset the unit will reboot from its p
If you want to continue using the new version, swap the Shadow and Main
3
versions. The new version is now defined as Main, and will be used each
the module reboots. The previous vers
Each SW version include
SW File, which is the name of the downloaded SW file. This name does not
necessarily include clear identification of the SW version number.
SW Version, which provides unambiguous identification of the SW
The SW Version Control submenu i
Show versions
Run from Shadow
BreezeMAX System Manual
ry default values. Refer to
on page 177 for information on the factory default values of
µ
e the NPU/ µBST resets it will reboot using the version defined
s two identifiers:
NPU/Micro Base Station
rt to their default values after the next
revious Main version.
ion is defined now as Shadow.
ncludes the following options:
NPU Menu
ow
time
version.
105
Advertisement
Table of Contents
