Table of Contents
Advertisement
Chapter 2 - Installation
If the MGMT port will be used for remote management, connect the it to the
4
appropriate data equipment (use a straight Ethernet cable to connect to a
hub/switch/router). The maximum length of the Ethernet cable is 100m.
For an AC model: Connect the power cord to the unit's AC socket, located on
5
the rear panel. Connect the other end of the
unit can operate with AC mains of 100-240 VAC, 50-60 Hz.
NOTE
For a DC m
6
the rear panel. Connect the other end of the power cord to the -48 VDC powe
source.
Connect the IF cable (already connected at the other end to the AU-ODU) to
7
the ODU 1 connector. To avoid transmissions at un
that the frequency and bandwidth parameters are properly configured before
connecting the IF cables.
64
The color codes of the power cable are as follows:
Brown
Blue
Yellow/Green
odel: Connec
t the power cord to the unit's DC socket, located on
power cord to the AC mains. The
Phase
~
Neutral
0
Ground
desired frequencies, verify
BreezeMAX System Manual
r
Advertisement
Table of Contents
