Table of Contents
Advertisement
Chapter 4 - Operation and Administration
4.9.6.3.3
Phy Parameters
The SU Phy Parameters menu in
4.9.6.3.3.1 Show
Select this option to view the cu
parameters.
4.9.6.3.3.2 Update
Sel
ect this option to upd
4.9.6.3.3.3 Bandwidth (MHz)
The frequency bandwidth used by the radio. A change in the Bandwidth
par
ameter will take effect only after
The a
vailable options are:
1 – 1.75 MHz
2 – 3.
5 MHz
The
default is 3.5 MHz.
4.9.6.3.3.4 Uplink (Tx) Frequency (MHz)
The frequency used in the uplink (from SU to AU/µBST). The frequency in the
dow
nlink (AU/µBST to S
A change in the Uplink Frequency parameter will take effect only after resetting
the SU.
The
resolution is in steps of 0.125 MH
Bandwidth, as follows:
For
a Bandwidth of 3.5 MHz: 3401.2
For
a Bandwidth of 1.75 MHz: 3400
The de
fault is 3451.75 MH
4.9.6.3.4 Multirate and ATPC Parameters
The Multirate and ATPC mechani
option to
Show Multirate
curren
t status of the applicable param
set uplin
4.9.6.3.4.1 Sh
ow
The Show option enables viewing the current status of the following parameters:
Uplink RSSI (dBm)
142
ate any of the Phy parameters. The Phy parameters are:
U) is the Uplink frequency plus 100 MHz.
z.
temporarily control them locally
and ATPC Status and Para
k and downlink rates per SU only whe
cludes the following options:
rrent value/option of the Phy (Physical Layer)
resetting the SU.
z. The available values depend on the
5 to 3498.25.
.375 to 3499.125.
sm are controlled by the AU/µBST (except to the
at the SU for testing purposes). The
meters option enables viewing the
eters. The Set Rates option can be used to
n Multirate is disabled.
BreezeMAX System Manual
Advertisement
Table of Contents
