Table of Contents
Advertisement
Chapter 4 - Operation and Administration
The Enter the passwod me
4
the Enter key to get to the Main menu.
NOTE
If yo
u forgot the password, type "help" to rec
Contact Alvarion's Customer Service and provide the challenge string (after user identification) to
receive a temporary password. You can use this password only once to enter the program. The
pas
sword must be
administrator should be notified of this new password. Five consecutive errors in entering the
temporary password will invalidate it. In this case, repeat this procedure to receive a new challenge
string for a new temporary password.
4.2.2
Using the Monitor Program
This se
ction describes the
Each m
running SW version
Monit
displayed after the unit t
Each menu or submenu displays a list of numbe
opti
on, enter the num
Enter key.
At any point in the program, you can use the Esc key to return to
menu (one level up) wit
The
first selectabl
the current config
additional st
For certain parameters, an updated value is applied only afte
entering a specific command. In these parameters, the config
differ from the actual value. If the
value both values will be displaye
and t
means that the configured bandwidt
1.7
5 MHz, and the current actual ba
For certain parameters the actual values may not be available (such as when
pre-configuring an AU that is not yet
of NA (Not Available) will be displayed.
The Update/Add options will display all applicable parameters line by line,
allowing to conveniently edit all of them. T
each parameter. To keep the current value - press Enter. To change it - enter
a new value and press Enter.
86
ssage is displayed. Enter the password and press
changed during the session to a different "permanent" password. The
Monitor program structure and navigation rules.
enu specifies the unit type (BreezeMAX NPU or µBST), the
enu or subm
and a description of the menu. When accessing the
or program using T
elnet, the IP address of the applicable port is
ype.
ber of the required option at the > prompt and press the
hout applying any change.
e item in most menus is the Show option, enabling to view
uration of the applicable parameters. For some menus some
atus inform
ation is displayed.
he second is the actual value. For
eive a challenge string consisting of 24 characters.
red options. To access an
configured value differs from the actual
d, where the first one is the configured value
example: "Bandwidth (MHz): 1.75, 3.5"
h, to be applied after the next reset, is
ndwidth is 3.5 MHz.
installed). For these parameters a value
he current value is displayed for
BreezeMAX System Manual
the previous
r reset or after
ured value may
Advertisement
Table of Contents
