Table of Contents
Advertisement
Chapter 4 - Operation and Administration
The default value is 10 minutes.
4.7.3
Configuration
The NPU Confi
Configuration me
functionality of the MGMT and DATA ports,
management s
The following are the guidelines for configuring these parameters:
All IP parameters o
values shall be us
The Destination Subnet parameters of the MGMT port enable defining an
additional subne
a router to the MGMT port. If OOB management via a router connecte
MGMT port is used, the parameters should be configured to ensure d
subnets for the D
Destination Subnet.
Authorized Manager(s) must be configured properly to enable remote
management using AlvariSTAR (or another SNMP based application).
The NPU Confi
Management Port
Data Port
Authorized Managers
Bridge
4.7.3.1
Management Port Parameters
These parameters define the IP parameters for the MGMT port, when this port is
used for Out-O
The Ethernet interface
Negotiation, enabling communication at either 10 Mbps or 100 Mbps.
The Ethernet int
operate either using Auto Negotiation or at a fixed speed/duplex mode (enabling
selection between 10 Mbps Half Duplex, 10 Mbps Full Duplex, 100 Mbps Half
Duplex or 100 Mbps Full Duplex).
108
guration menu, and the applicable options in the µBST
nu, enables viewing and updating parameters that define the
tations and bridging functionality.
f both ports should be configured. Otherwise, default
ed.
t of stations that can manage the device when connected via
ata port, the Management port and the Management Port
guration menu includes the following options:
f-Band (OOB) management.
of the MGMT port in the NPU operates using Auto
erface of the MGMT port in the µBST can be configured to
the properties of authorized
BreezeMAX System Manual
d to the
ifferent
Advertisement
Table of Contents
