Multiturn Limit Disagreement Alarm (A.cc0) - YASKAWA SGDV series User Manual

Set the value, the desired rotational amount -1, to Pn205.
Factory Setting (= 65535)
Rotational
0
data

4.5.7 Multiturn Limit Disagreement Alarm (A.CC0)

When the multiturn limit set value is changed with parameter Pn205, a multiturn limit disagreement alarm
(A.CC0) will be displayed because the value differs from that of the encoder.
Alarm
Display
A.CC0 Multiturn Limit Disagreement
If this alarm is displayed, perform the operation described below and change the multiturn limit value in the
encoder to the value set in Pn205.
Step Display after Operation
A . C C 0
F n 0 1 2 : S o f t V e r
1
F n 0 1 3 : M t u r n L m S e t
F n 0 1 4 : O p t I n i t
F n 0 1 B : V i b l v l I n i t
A . C C 0
M u l t i t u r n L i m i t
2
S t a r t
R e t u r n : [ S E T ]
A . C C 0
M u l t i t u r n L i m i t
3
S t a r t
R e t u r n : [ S E T ]
A . C C 0
F n 0 1 2 : S o f t V e r
4
F n 0 1 3 : M t u r n L m S e t
F n 0 1 4 : O p t I n i t
F n 0 1 B : V i b l v l I n i t
5 To enable the change in the setting, turn the power OFF and ON again.
+32767
Forward
Reverse
-32768 Motor rotations
Alarm Name Alarm Output
- F U N C T I O N -
S e t
: [ D A T A ]
S e t
: [ D A T A ]
- F U N C T I O N -
Other Setting (≠65535)
Pn205 setting value
Rotational
0
data
Different multiturn limits have been set in the
OFF (H)
encoder and SERVOPACK.
Keys
Press the Key to select the utility function. And
press the or
Press the Key to view the execution display of
Fn013.
Note: If the display is not switched and "NO-OP" is
displayed in the status display, the Write Pro-
hibited Setting (Fn010 = 0001) is set. Check
the setting and reset.
Press the Key to set the multiturn limit value.
When the setting is completed, the status display
shows "DONE" for one second. The status display
then returns to show "A.CC0" again.
Note: If the
Key, the multiturn limit value will not be reset.
Press the Key to return to the display the proce-
dure 1.
4.5 Absolute Encoders
Reverse
Forward
Motor rotations
Meaning
Operation
Key to select the Fn013.
Key is pressed instead of the
4
4-47