SHENZHEN ENCOM ELECTRIC TECHNOLOGIES CO. enc eds800-2s0002n User Manual page 68

F2.12 LED display control 2
F2.12 make use of 4 bit of the parameter to set if C-11－C-14 is displayed in
parameter, thereinto 0 indicates not displayed, 1 indicates displayed. Set parameter of 4
bit is as following figure:
4th bit
Parameter operation
F2.13
control
st
LED 1 bit
0: all parameter allowed to be modified
1: except this parameter，all other parameter not allowed to be changed
2: except F0.01 and this parameter，all other parameter not allowed to be
changed
nd
LED 2 bit
0: no action
1: renew factory default
2: clear history failure record
rd
LED 3 bit
entering into Locc status）
0: lock all buttons
1: all the buttons locked except STOP key
2: all the buttons locked except
3: all the buttons locked except RUN, STOP key
4: all the buttons locked except SHIFT, STOP key
EDS800 series Service Manual
3rd bit 2nd bit
（After setting, It will be valid after pressing MENU key for 5 seconds and
－
Range：0000 1111
1st bit
C-11： analog input VCI
C-12： analog input CCI
C-13：reserved
C-14：outer pulse input
st
Range：LED 1
LED 2
LED 3
, STOP key
63
bit: 0~2
nd
bit: 0~2
rd
bit: 0~4
1111
000