Dodge RAM TRUCK 1500 1995 Service Manual page 517

8S - 4 POWER WINDOWS - —
Fig. 8 Window Regulator Mounting Screws
(6) Move glass to allow access to glass channel at­
taching hardware (Figs. 9 and 10).
Fig. 9 Glass Channel Front Attaching Nut
(7) Slide the glass rearward to remove nuts from
door panel.
(8) Pull glass to full up position and tape to door.
(9) Unplug wiring connector from motor.
(10) Remove 2 window track and 2 regulator
screws (Fig. 8).
(11) Loosen 2 regulator screws (Fig. 8).
(12) Remove window regulator from door (Fig. 11).
(13) To install, place regulator inside door and
slide 2 loose screws into slots in door.
Fig. 10 Glass Channel Rear Attaching Nut
J948S-7
Fig. 11 Window Regulator Remove
(14) Install remaining 4 screws.
(15) Tighten 4 regulator screws to 12 N-m (105 in.
lbs.).
(16) Move glass as far rearward into channel as
possible and push down. Tighten 2 window track
screws to 12 N-m (105 in. lbs.).
(17) Attach door glass by sliding 2 nuts into the
slots on the channel (Figs. 9 and 10). Tighten door
glass nuts to 12 N-m (105 in. lbs.).
(18) Connect wire harness connector to regulator.
(19) Using 3M 08044 or 3M 08041 adhesive/seal­
ant, install plastic watershield.
(20) If equipped, install power mirror switch into
trim panel using retaining nut (Fig. 7).
(21) Place trim panel in the installation position
and press in nylon retainers.
(22) Install door pull cup and trim panel attaching
screws.
(23) Install power window/lock switch panel.
To aid in removal of the trim panel, start at
the bottom of the panel.
(4) Using a wide flat-bladed tool such as a trim
stick, pry trim panel away from door around perime­
ter and remove trim panel
(5) Roll door watershield away from bottom of door
to allow access to regulator screws (Fig. 8).