7 - 21
COOLING SYSTEM SERVICE PROCEDURES
lit
(3) Remove the bolt retaining the wiring harness
near the top of water pump. Position wire harness to
the side.
(4) Remove the accessory drive belt. Refer to the
Engine Accessory Drive Belt section of this group.
(5) Remove water pump mounting bolts (Fig. 24).
Fig, 24 Pump Removal/Installation—5.9L
Diesel
(6) Clean water pump sealing surface on cylinder
block.
INSTALLATION
(1) Install new o-ring seal in groove on water
pump (Fig. 25).
Fig. 25 Pump O-ring Seal—5.9L Diesel
(2) Install water pump. Tighten mounting bolts to
24 N-m (18 ft. lbs.) torque.
(3) Install accessory drive belt. Refer to the Engine
Accessory Drive Belt section of this group.
(4) Install the bolt retaining the wiring harness
near top of water pump.
(5) Fill cooling system. Refer to Refilling Cooling
System in this section.
(6) Connect both battery cables.
(7) Start and warm the engine. Check for leaks.
WATER PUMP BYPASS HOSE
A water pump bypass hose (Fig. 26) is used be
tween the intake manifold and water pump on all
gas powered engines. To test for leaks, refer to Test
ing Cooling System for Leaks in this group.
FAN BLADE
WATER
WATER PUMP
VISCOUS FAN DRIVE
J9307-32
Fig. 26 Water Pump Bypass
Hose—Typical
REMOVAL—3.&L
V*6 OR 5.2/5»BL ¥-8
ENGINES
WITHOUT
AIR
CONDITIONING
(1) Partially drain cooling system. Refer to Drain
ing Cooling System in this group.
Do not waste reusable coolant. If the solution is
clean, drain the coolant into a clean container for re
use.
WARNING: CONSTANT TENSION HOSE C L A M P S
A R E U S E D ON MOST COOLING S Y S T E M H O S E S .
W H E N
REMOVING OR INSTALLING, U S E ONLY
TOOLS DESIGNED FOR SERVICING THIS T Y P E OF
CLAMP, SUCH A S S P E C I A L CLAMP TOOL (NUMBER
6094) (FIG. 27). SNAP-ON CLAMP TOOL (NUMBER
HPC-20) MAY B E U S E D FOR L A R G E R C L A M P S . AL
WAYS W E A R S A F E T Y G L A S S E S W H E N SERVICING
CONSTANT TENSION C L A M P S .
CAUTION: A number or letter is stamped into the
tongue of constant tension clamps (Fig. 28). If re
placement is necessary, use only an original equip
ment clamp with a matching number or letter.
(2) Loosen both bypass hose clamps and position to
the center of hose.
(3) Remove hose from vehicle.