Dodge RAM TRUCK 1500 1995 Service Manual page 495

8L -12
LAMPS
B R
Fig. 12 Side Identification Lamps
SIDE IDENTIFICATION (ID) LAMP BULBS
The bulbs in the side ID lamps can not be replaced.
If a bulb should fail, the entire lamp would require
replacement.
REAR IDENTIFICATION (ID) LAMPS
The bulbs in the side ID lamps can not be replaced.
If a bulb should fail, the entire lamp would require
replacement.
REMOVAL
(1) Remove screws holding rear ID lamps to cargo
box (Fig. 13).
TAILGATE
MARKER LAMPS J948L-10
Fig. 13 Rear Identification Lamps
(2) Separate ID lamps from cargo box.
(3) Disengage ID lamp wire connector from body
wire harness.
(4) Separate ID lamp from vehicle.
INSTALLATION
Reverse the removal procedure.
REAR IDENTIFICATION (ID) LAMP BULBS
The bulbs in the rear ID lamps can not be re­
placed. If a bulb should fail, the entire lamp would
require replacement.
LICENSE PLATE L11P PANEL
REMOVAL
(1) Remove screws holding license plate panel to
cargo box.
(2) Disengage license plate lamp wire connector
from body wire harness (Fig. 14).
LICENSE
PLATE
LAMP J948L-7
Fig. 14 License Plate Lamp Panel
(3) Separate license plate lamp from vehicle.
INSTALLATION
Reverse the removal procedure.
LICENSE PLATE LAMP BULB
REMOVAL
(1) Remove license plate lamp lens.
(2) Pull bulb from license plate lamp.
INSTALLATION
Reverse the removal procedure.
DOME LAMP
REMOVAL
(1) Using a suitable flat blade screw driver, pry
dome lamp lens from dome lamp.