Dodge RAM TRUCK 1500 1995 Service Manual page 430

8E - 20 INSTRUMENT PANEL AND GAUGES
B R
(3) Remove ash receiver as described in Ash Re­
ceiver Remove/Install.
(4) Carefully pry bezel away from instrument
panel to disengage clips (Fig. 5).
J948E-46
Fig. 5 Instrument Bezel Remove/Install
(5) Unplug connector from cigar lighter.
(6) Unplug connector from auxiliary power outlet.
(7) Reverse removal procedures to install.
CIGAR LIGHTER/POWER OUTLET REMOVE/
INSTALL
(1) Remove cluster bezel as described in Cluster
Bezel Remove/Install.
(2) Unscrew cigar lighter/power outlet housing
from rear of cluster bezel (Fig. 6).
ELECTRICAL
CONNECTOR
CLIPS
J948E-10
Fig. 6 Cigar Lighter Remove/Install
(3) Remove cigar lighter/power outlet from front of
bezel.
(4) Reverse removal procedures to install.
INSTRUMENT CLUSTER REMOVE/INSTALL
(1) Disconnect battery negative cable.
(2) Remove cluster bezel as described in Cluster
Bezel Remove/Install.
(3) Remove knee blocker as described in Knee
Blocker Remove/Install.
(4) Pull PRND21 cable and twist to remove from
position arm (Fig. 7), if equipped.
PRNDL
CABLE
POSITION
ARM
PUSH TAB
UP
STEERING
COLUMN
J948E-4
Fig. 7 PRND21 Cable Remove -
(5) Push tab on bottom of cable retainer up then
squeeze sides to remove retainer from column.
(6) Remove 4 screws that hold cluster (Fig. 8).
J948E-11
Fig. 8 Instrument Cluster Remove/Install
(7) Pull cluster rearward and unplug 2 electrical
connectors (Fig. 9).
(8) Remove cluster.
(9) Reverse removal procedures to install. Refer to
Group 21 - Transmission and Transfer Case for
PRND21 cable adjustment procedure.
CLUSTER LENS AND MASK REMOVE/INSTALL
(1) Remove cluster assembly as described in In­
strument Cluster Remove/Install.
(2) Remove 7 screws and lens (Fig. 10).
(3) Remove gauge mask (Fig. 11).