Dodge RAM TRUCK 1500 1995 Service Manual page 490

IPS
CENTER OF
VEHICLE T O
CENTER OF ,
HEADLAMP
LENS
LOW BEAM HOT
SPOT AREA
FLOOR TO
CENTER OF
H E A D L A M P
LENS
VEHICLE
CENTERLINE
F R O N T OF
H E A D L A M P
938 L-61
LEFT AND RIGHT
ADJUSTMENT SCREW
UP AND DOWN
ADJUSTMENT SCREW
Fig. 1 Headlamp Alignment Screen—Typical
(4) From behind front bumper, remove screws hold­
ing bottom of headlamp module to radiator closure
panel.
(5) Separate headlamp module from radiator clo­
sure panel.
(6) Disengage wire connector from headlamp bulb.
(7) Separate headlamp module from vehicle.
INSTALLATION
Eeverse the removal procedure.
HEADLAMP BULB
On driver side and on vehicles with dual batteries,
the headlamp assembly must be removed to service
the headlamp bulb.
J 9 5 8 L - 2 3
Fig. 2 Aero Headlamp Alignment
alignment screen 100 mm (4 in.) below the fog lamp
centerline and straight ahead.
HEADLAMP MODULE
REMOVAL
(1) Release hood latch and open hood.
(2) Remove park and turn signal lamp.
(3) Remove screws holding top of headlamp module
to radiator closure panel (Fig. 4).
REMOVAL
(1) Release hood latch and open hood.
(2) To remove headlamp assembly on drivers side
or passenger side when equipped with dual batteries,
refer to Headlamp Removal paragraph of Exterior
Lamps section.
(3) Disengage wire connector from headlamp bulb.
(4) Remove retaining ring holding bulb to head­
lamp (Fig. 5).
(5) Pull bulb from headlamp.