Dodge RAM TRUCK 1500 1995 Service Manual page 494

LAMPS 8L -II
(5) Disengage tail lamp wire connector from body
wire harness.
(6) Separate tail lamp from vehicle.
INSTALLATION
Reverse the removal procedure. -
TAIL, STOP, TURN SIGNAL AND BACK-UP LAiP
BULB—PICKUP
REMOVAL
(1) Remove screws from tail lamp and separate tail
lamp from cargo box (Fig. 10).
RETAINING
STUDS
J948L-6
Fig. 10 Tail, Stop, Turn Signai and Back-up Lamp
Bum
(2) Remove socket from tail lamp.
(3) Pull bulb from socket.
INSTALLATION
(1) Install bulb in socket.
(2) Install socket in tail lamp.
(3) Position tail lamp in cargo box and' install
screws (Fig. 10).
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMPS—CHASSIS CAB
REMOVAL
(1) Remove nuts holding tail lamp to mounting
bracket (Fig. 11).
(2) Disengage tail lamp wire connector from body
wire harness.
(3) Separate tail lamp[ from vehicle.
Reverse the removal procedure.
BRACKET J948L-9
Fig. 11 Tail, Stop, Turn Signal and Back-up
Lamps—Chassis
Cab
TAIL, STOP, TURN SIGNAL AND BACK-UP LAiP
BULB—CHASSIS CAB
REMOVAL
(1) Remove screws holding tail lamp lens to lamp
body.
(2) Separate lens from lamp.
(3) Remove bulb from socket.
I N S T A L L A T I O N
Reverse the removal procedure.
SIDE IDENTIFICATION (ID) LAMPS
REMOVAL
(1) Using a flat blade screw driver, disengage clips
holding ID lamp to retainer (Fig. 12).
(2) Separate ID lamp from retainer.
(3) Disengage wire connector from body wire har­
ness.
(4) Separate lamp from vehicle.
(5) Remove screws holding lamp retainer to rear
fender.
(6) Separate retainer from rear fender.
INSTALLATION
Reverse the removal procedure.