Dodge RAM TRUCK 1500 1995 Service Manual page 493

8L L A M P S
separate socket from lamp.
INSTALLATION
(1) Install socket in lamp and rotate socket 1/4
turn clockwise.
(2) Position clearance lamp on roof.
(3) Install screws holding clearance lamp lens to
roof panel. Tighten to 1 N-m (13 in. lbs.).
ROOF CLEARANCE
LAMP BULB
For bulb replacement refer roof clearance lamp re­
moval/installation procedure. .
CENTER HIGH MOUNTED S T O P L A M P ( C H M S L )
R E M O V A L
(1) Remove screws holding CHMSL to roof panel
(Fig. 8).
SCREW J948L-4X
Fig. 8 Center High Mounted Stop Lamp
(2) Separate CHMSL from roof.
(3) Disengage wire connector from body wire har­
ness.
(4) Separate CHMSL from vehicle.
INSTALLATION
Reverse the removal procedure.
CARGO
LAMP
The cargo lamp is incorporated into the CHMSL, if
equipped. Refer to Center High Mounted Stop Lamp
paragraph for proper procedures.
GEKTER
mm
COUNTED
S T O P
L A 1 P
(CHMSL) '
mm
(1) Remove screws holding CHMSL to roof panel.
(2) Separate CHMSL from roof.
(3) Remove socket from lamp (Fig. 9).
(4) Pull bulb from socket.
mmwMLLAwmm
(1) Install bulb in socket.
(2) Install socket in lamp.
(3) Position CHMSL in roof.
(4) Install screws holding CHMSL to roof panel.
C A R G O
LAMP
B U L B
The cargo lamp bulb is incorporated in the CHMSL
assembly, refer to the CHMSL bulb removal and in­
stallation procedure for bulb replacement.
Fig. 9 Cargo or Center High Mourned Stop Lamp
Bulbs
H E A D L A M P S W I T C H
To remove or replace the headlamp switch. Refer to
Group 8E, Instrument Panel and Gauges.
.oa imp S W I T C H
The fog lamp switch is located to the right of the
overdrive lock-out switch. For installation and re­
moval procedures, refer to Group 8E, Instrument
Panel.
TAIL, STOF, TURN SIGNAL AND BACK-UP
(1) Release tailgate latch and open tailgate.
(2) Remove screws holding tail lamp to cargo box
(Fig. 10).
(3) Disengage clips holding tail lamp to cargo box.
(4) Separate tail lamp from cargo box.