Dodge RAM TRUCK 1500 1995 Service Manual page 192

5 - 20 POWER BRAKE BOOSTER—BRAKE PEDAL —BRAKELIGHT SWITCH
B R
Fig. 11 Brakelight Switch Bracket Position
(9) Remove brake pedal and pedal shaft from vehi­
cle.
BRAKE PEDAL INSTALLAT101
(1) Replace bracket and pedal bushings if neces­
sary. Lubricate shaft bores in bracket and pedal be­
fore installing bushings. Use Mopar Multi-mileage, or
DOW/GE silicone grease.
(2) Apply liberal quantity of Mopar multi-mileage
grease, or DOW/GE silicone grease, to pedal shaft
and to pedal and bracket bushings.
(3) Position brake pedal in mounting bracket.
(4) Slide pedal shaft into bracket and through
pedal from passenger side.
(5) Push pedal shaft out driver side of mounting
bracket just enough to allow installation of retaining
E-clip (Fig. 12). •
PEDAL SHAFT
Fig. 12 Brake Pedal Mounting (With Automatic
Transmission)
(6) Push pedal shaft back toward passenger side of
bracket and install remaining E-clip on pedal shaft.
(7) Install booster push rod on brake pedal. Secure
push rod to pedal with washer and retaining clip
(Fig. 6).
(8) Install brakelight switch bracket.
(9) Install brakelight switch.
(10) Install knee bolster.