mm
IGNITION SYSTEMS
30 - 35
908D-18
Fig. 9 ignition Switch View From Column
(a) With lock cylinder and ignition switch in
Lock position, insert lock cylinder into ignition
switch until it bottoms.
Fig, 10 Ignition Switch Mounting Pad
(b) Insert ignition key into lock cylinder. While
gently pushing lock cylinder in toward ignition
switch, rotate ignition key to end of travel.
(6) Install retaining screw into bracket and lock
cylinder. Tighten screw to
3±.5
N-m
(26±4
in. lbs.)
torque.
(7) Install steering column covers. Tighten screws
to 2 N-m (17 in. lbs.) torque.
(8) If vehicle is equipped with a tilt steering col
umn, install tilt lever.
(9) Connect negative cable to battery.
(10) Check for proper operation of halo light, shift
lock (if applicable), and column lock. Also check for
proper operation of ignition switch accessory, lock,
off, run, and start positions.